CV Inputs inverted after v1.2 update

[hermansmasher]

I know, this is more of a minor annoyance but I didn't know where else to put this.
After looking deeper into #50 I decided to once again reinstall the fw v1.2 and updating the patch, just to make sure I'm not crazy or that I missed anything.
So regarding #50 it's all the same. But what I found is, that although no cfg file is present after the installation, the CV Inputs are inverted on startup of the device -> so positive voltage applied at the CV decreases filter freq. and so on. The internal LFOs CV assignments appear to work normal. This was not the case in fw 1.1 as far as I remember.

This is rather just an odd inconvenience, because it can be resolved by deleting the CV-Assignment with the RECORD and RANDOM Combo in the CV-Mod Amount menu. Then it works as expected.
I just thought it is odd that this would be the new default and thus I wanted to report it .. unless, this is on purpose?

EDIT: Also, the manual states that by default modulation is sent to the Filter-Freq. (CUTOFF). This is not the case after powering up. Not that I mind, but it just not correct and I remember this was not the case in fw. 1.1

[hirnlego]

Hi!

I tried removing every configuration file and reflashing the patch but I cannot replicate this issue, neither the inverted CVs nor the missing default modulation, both work as expected...

[hermansmasher]

Interesting. Just a few minutes ago I updated to v1.2.1. I made sure there is no cfg file .. and again, all CV Inputs are inversed as described above. Also no normalization of the MOD to filter cutoff.

I tried overwriting this by deleting the CV-Assignment with the RECORD and RANDOM Combo in the CV-MOD AMT Menu (green mode) and then saving it to flash (long-press on MOD AMT) .. but that didn't work, all CV-INs are inversed on startup.

But it gets even weirder, because I tried also saving different knob states to flash (just to make sure that saving to flash works in general). I tried different settings of the resonator, filter cutoff, echo and ambience.. turns out, that a saved value (knob position) only comes up on startup, when the physical knob is below the saved value. Then it catches up to the saved value (this is even audible). But when the physical knob is on a higher value than the saved one, it will startup at the present value of the physical knob. I didn't try all the other knobs yet, but filter resonance knob does not show this behavior.

I checked again, and after I uploaded the patch, only .cv .alt .prm .mod were listed in the resources tab.

I didn't touch the Startup Settings, they were all in default.