From 6f7d105605164da026ae8c33bc15527194e06adc Mon Sep 17 00:00:00 2001 From: MrAlders0n Date: Mon, 28 Sep 2026 12:22:17 -0400 Subject: [PATCH] docs: point native MQTT firmware at the official observer flasher --- docs/mqtt-main.md | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/docs/mqtt-main.md b/docs/mqtt-main.md index 6df9d1b..5e2f153 100644 --- a/docs/mqtt-main.md +++ b/docs/mqtt-main.md @@ -35,7 +35,7 @@ This method runs directly on a Heltec V3 or V4 board with no companion device ne - **Requires**: A Heltec V3 or V4 with the MQTT-enabled firmware flashed - **Best for**: The simplest hardware setup, since no secondary computer is needed -Community MQTT observer firmware is available for supported boards, including Heltec V3 and V4. One option is [Offband observer firmware](https://github.com/OffbandMesh/meshcore-firmware), which provides build, flashing and configuration instructions. Check its supported boards and broker settings before flashing. MeshMapper does not maintain that firmware. If you prefer a supported setup without custom firmware, use [MeshCore Packet Capture](mqtt-python.md) or [PyMC](mqtt-pymc.md). +Flash the observer firmware from the [MeshCore observer flasher](https://observer.gessaman.com/), built by agessaman/HerculesMulligan. It runs in your browser and walks you through flashing and setup. The source is in [agessaman/MeshCore](https://github.com/agessaman/MeshCore/tree/mqtt-bridge-implementation). ### 4. PyMC