Error message feedback in DTK

[KobusVanRooyen]

Default scenario.esdl.txt

When I run this esdl file in the DTK production environment the following happens:

Couple of issues:

1. The error in the log file does not make sense. Log file states that the installed capacity if 0.35MW for heating demand 2. But this is not true since the installed capacity is 350MW. There might be an issue that message being displayed is an old message stored in memory, and it was not cleared by MESIDO when a new run was started. Let me know if I can explain this a bit better in a meeting.

2. The error message feedback in the DTK prod env is not working. Not sure if it is because of an issue on MESIDO's side. But this is what I see

3. By the way, this edsl file will not not since the actual error should be something like "heating demand not matched ..." (since Pipe 3 is too small), but we are not seeing this error.

[gopalangj]

Hi Kobus,
I just tested them now and seems to be working from my end.
I've run the esdl both in the production and the test environment.

1. I do not get the Insufficient installed capacity error.

Of course, the heat demand not matched error is expected since Pipe 3 is not under-dimensioned. Increasing it to DN200 already works.

2. I do not have the Error feedback in the map-editor

I did try to run MESIDO locally to double check and ended up with the "...heat demand not matched" error there too.
I think this has to do with how memory buffers are cleared between the runs. Perhaps the old logs were not flushed that had resulted into these incorrect error message pickups?

Let me know if I can clarify this further