Home Y before X

[seidler2547]

Please change the homing sequence to home Y first, then X. It is very important to home Y first, because the Y-path is always unrestricted, but the X path has obstructions like the tray lever and the stepper motor in the back. Homing X first is very dangerous.

[suchmememanyskill]

Y is not unrestricted. If X is left at or near max, you will engage the filament cutter if you home Y first.

There is no good way to home the CC. It's a mess.

[seidler2547]

But it's still more reasonable, and also how stock firmware does it. I think stock even moves a little left before homing Y so that it would not run into the filament cutter.

[suchmememanyskill]

Stock doesn't do it like this. We are currently identical to stock, home x, home y, home x, home y. Stock homes x left though, not right.