i'm working in a project to add brake and light control on my tsds2b . I did found valuable resource and information here specially wiring of the higo .
My extension cable have same pin number/wire color as here
https://image.easyeda.com/histories/8dac0a3afe4941cd88897efa33f119db.png)
But when it come to pin function nothing match here is what my motor has
(confirmed by probing with meter, logic analyser with uart decoding + acting on brake and display on/off)
- 1 Gnd
- 2 throttle analog 0 to 3.5V
- 3 ? 4.3V ? 5V for brake sensor ?
- 4 Rx
- 5 brake (active low)
- 6 TX
- 7 Vin
- 8 VBat
note number as per above schematic while front viewing the female connector/cable.
So are their multiple tsdz2/tsdzb wiring . or am i missing something ?
My kit is TSDZ2B 500W 48V from varstrom eu with edk01 (3 wire brake, throtle + higo 5 display after higo 8 , 1 to 4 cable)
feel free to move this to discussion /question ... i just didn't knew how to create it as such
i'm working in a project to add brake and light control on my tsds2b . I did found valuable resource and information here specially wiring of the higo .
My extension cable have same pin number/wire color as here
https://image.easyeda.com/histories/8dac0a3afe4941cd88897efa33f119db.png)
But when it come to pin function nothing match here is what my motor has
(confirmed by probing with meter, logic analyser with uart decoding + acting on brake and display on/off)
note number as per above schematic while front viewing the female connector/cable.
So are their multiple tsdz2/tsdzb wiring . or am i missing something ?
My kit is TSDZ2B 500W 48V from varstrom eu with edk01 (3 wire brake, throtle + higo 5 display after higo 8 , 1 to 4 cable)
feel free to move this to discussion /question ... i just didn't knew how to create it as such