Using Soilsens with openplantbook and Plant Monitor integration

[Bendoon]

• I've got my Soilsens sensors setup correctly and reporting to HA
• Using a single plant as an example, my bird_of_paradise
• I add a plant bird_of_paradise, it pulls from openplantbook the recommended humidity levels (let's say 80% max)
• I calibrate my sensor during a watering session
• I start the calibration on the dryest I want the soil, record it, then water at the most moist I want it
• this is where the issue happens, so my 100 moisture is actually not a "problem", it's acceptable, the sensor reports 100% moisture, but the openplantbook integration flags it as an issue as 80% is the max

Has anyone figured out anything to do with this? Curious what other setups folks are using. Or if you're just avoiding openplantbook while using them!

[PricelessToolkit]

I am using "Plant Monitor" integration, what is a openplantbook ?

[Bendoon]

I am using 'Plant Monitor' (custom integration that replaces core component) and 'Flower Card' but with 'OpenPlantBook', which scrapes from a DB of plants the ideal humidity, temperature etc.

Since when scraping the ideal moisture level for most plants sits between 60-70%, and my 'Smaug' here reports that it's at 95% moisture (which is fine, since it's calibrated to being the most moist I want it and the most dry), but it causes the card to report that there is an issue.

Wondering if you, or anyone else has ran into this, and how you've handled it? I've considered just calibrating the soil sensor from dry soil to wet (water).