Void maps don't get run when expected.

[Torr1978]

Attached should be screenshots of the settings I'm using and the graphs that show the void maps aren't being run at zone 100. In fact a large number of them fail to be run at all before the auto portal occurs.

I may have messed up the config someplace else and so I've also attached the AutoTrimp Setting export.
AutorimpConf.txt

[Blauelf]

Is it possible that you finish all those extra zones without dying once? Then it would require a Trimp suicide to enter the maps screen.

[Torr1978]

Yes, that does happen.

[Torr1978]

Just now I watched it do a prestige gather from the maps and once that was done it went back to advancing at zone 115 with 4 void maps in queue instead of doing the void maps. I assume because it wasn't in the last row of cells when it was in the maps screen.

It really does appear that they need to die in just the right range of cell in the zone to enter the void map process.

[genbtc]

I will look into this - any further info appreciated.

[Torr1978]

Thank you for taking an interest in this genbtc.

The real problem appears to be that my Trimps are too tough for the challenge they are working through (using the Life challenge they are doing roughly 1mil He/Hr). As a result they are not dying in the last 8 cells of any zone before the end of the challenge but after the level selected to start doing void maps.

I think the solution might be to have an option that says works in a way like this "abandon trimps to force void maps before challenge is complete." I don't think that there is a time you wouldn't want to run the void maps before ending a challenge but maybe leaving it an option is a good thing.

What kind of details would you like me to provide?

[Akenator]

Are you running this in another tab?

The browser can only process so much if its not the active tab, and i find that it occasionally misses void maps if you're doing something else on your computer. It screws the graphs up bad also.

[Torr1978]

I wondered if that was it, so I ran tests where I sat and watched it run through the area making sure that the tab had focus. I may have a setting set incorrectly somewhere but I believe the issue is that the trimps need to suicide to run void maps on the indicated zone/level. If they don't die off naturally in the last 8 cells or so then the void maps are held over until the next time they do die in the last 8 cells (I think it's cells 92-100 that it tries to run void maps in). If I click the "Abandon Trimps" button in that range of cell the void maps do process correctly.