Adding interface for Elegoo Centauri Carbon

[jesster3757-gif]

I purchased the Panda breath to use with my Elegoo Centauri carbon 1, I was able to connect and bind it with the Klipper printer settings, but the Bambu lab would not work. The Klipper settings do not allow the Elegoo to to send heated temp settings to the panda breath. It only reads chamber temp, but as you probably know, to use the auto mode the heated must be monitored to trigger it to turn on.

i wish the bigtreetech team would be able to add an Elegoo Centauri Carbon to the Panda breath settings? Your help with this would be helping a ton.

[Lyle-68]

It has been reported to the person in charge of Panda Breath, and they will reply to you once there is any progress.

[CurtHuB2026]

Can you share how you were able to connect and bind it with the Centauri carbon? Thanks

[jesster3757-gif]

Using the panda breath web interface I connected to my local WiFi, then under linking it to your printer there are 2 options bambu lab and klipper. The only way it linked was through klipper, but it did not work on auto, currently it can’t read the bed temp to turn on automatically. I am waiting for the panda breath to be updated to add elegoo printer interface.

[CurtHuB2026]

Using the panda breath web interface I connected to my local WiFi, then under linking it to your printer there are 2 options bambu lab and klipper. The only way it linked was through klipper, but it did not work on auto, currently it can’t read the bed temp to turn on automatically. I am waiting for the panda breath to be updated to add elegoo printer interface.

Okay, thanks. I've tried getting to bind to the printer and cannot get past that part for some reason, it won't drop down to where you can choose your printer, it just stays there without moving.