Bug: Model config change applies to a single mode even if the option is disabled

[azalty]

Describe the bug
In the IDE, it seems like when I change the model configuration for a specific mode (ex: Act), then switch to Plan, plan still uses the previously set configuration. I can see that it doesn't use the correct model (it uses the model from the previous configuration).

Going to the settings then shows a discrepancy, where the config name and model name don't match if I remember correctly.

To Reproduce
none

Expected behavior
Correctly change the configuration for both modes. No visual bugs.

Screenshots
none

Surface and Version:

• IDE
• Version 0.3.30

Additional context
none

[dirac-run]

To make sure I understand right, this only triggers when you use different models for Plan and Act mode right?

[azalty]

No. I have this option disabled. Dirac should use the same model for both, but it doesn't always seem to update properly for both modes.

Ex: using model 1. Plan and Act properly use model 1.

Changing to model 2 while using Plan: Plan now uses model 2, but switching to act still triggers model 1 calls. I have to manually go to the config, switch configs to another one then to the correct one again to properly change Act to model 2.