Hi i am quite new to this site but that FakeTec PCB caught my attention since it is extremly cost efficient already did some nodes with it. Version 4 already meets my need to 98% but soldering SMD Pin Headers to the button pads is always a real pain. I am aware that the design files for V4 are availible on this board but i lack the knowledge to use any other editor than EasyEDA by JLC PCB.
If some would be nice enough to help me get the last 2% by adding 2,54 mm THT Holes instead of SMD Pads for both buttons i would be really grateful
Hi i am quite new to this site but that FakeTec PCB caught my attention since it is extremly cost efficient already did some nodes with it. Version 4 already meets my need to 98% but soldering SMD Pin Headers to the button pads is always a real pain. I am aware that the design files for V4 are availible on this board but i lack the knowledge to use any other editor than EasyEDA by JLC PCB.
If some would be nice enough to help me get the last 2% by adding 2,54 mm THT Holes instead of SMD Pads for both buttons i would be really grateful