Auto squaring assistance needed #59
-
|
Howdy! I've been struggling to flash Auto squaring onto an SKR 1.3 and some SKR 1.4s for days now. XYZ controls work fine, but my A axis(second Y-axis) is not moving at all. The second Y axis limit switch is also not responding. I need someone to check if I'm doing something wrong, been at this for a few days, I'm not sure what else to do other than ask for help. Thanks! |
Beta Was this translation helpful? Give feedback.
Replies: 2 comments 1 reply
-
|
Figured it out, error 18 was throwing me off on gsender, had to invert e-stop and limit switch signals. prior to that I kept getting device descriptor request issues, not sure what that was, but redownloading the driver resolved that. |
Beta Was this translation helpful? Give feedback.
-
|
I would like to know where to change frequency from 120mhz to 100 mhz for base skr 1.4 Thanks! |
Beta Was this translation helpful? Give feedback.
-
|
I believe it is just choosing LPC1768 under MCU settings. |
Beta Was this translation helpful? Give feedback.
Figured it out, error 18 was throwing me off on gsender, had to invert e-stop and limit switch signals.
prior to that I kept getting device descriptor request issues, not sure what that was, but redownloading the driver resolved that.