Hello,
Following this guide, but with a different idea in mind, bridges that are printed with more flow/density will overall print way better (as bridge extrusions that are unsupported are not squeezed vertically and are round in nature and therefore would not touch side to side without increasing flow/decreasing distance), but will have overextrusion near the edges. This could also be mitigated by increasing PA for bridge skins. Hence my request to add an extra PA setting for bridge skins.
https://www.youtube.com/watch?v=eaasEkFULKE
Thank you for your efforts!
Hello,
Following this guide, but with a different idea in mind, bridges that are printed with more flow/density will overall print way better (as bridge extrusions that are unsupported are not squeezed vertically and are round in nature and therefore would not touch side to side without increasing flow/decreasing distance), but will have overextrusion near the edges. This could also be mitigated by increasing PA for bridge skins. Hence my request to add an extra PA setting for bridge skins.
https://www.youtube.com/watch?v=eaasEkFULKE
Thank you for your efforts!