The following SSH command responded with a non-zero exit status???

[mevam]

{ vagrant-alpine } master » vagrant up /cygdrive/g/vagrantCluster/vagrant-alpine
Bringing machine 'default' up with 'virtualbox' provider...
==> default: Importing base box 'maier/alpine-3.3.1-x86_64'...
==> default: Matching MAC address for NAT networking...
==> default: Checking if box 'maier/alpine-3.3.1-x86_64' is up to date...
==> default: Setting the name of the VM: vagrant-alpine-test
==> default: Clearing any previously set network interfaces...
==> default: Preparing network interfaces based on configuration...
default: Adapter 1: nat
default: Adapter 2: hostonly
default: Adapter 3: hostonly
==> default: Forwarding ports...
default: 22 (guest) => 2222 (host) (adapter 1)
==> default: Running 'pre-boot' VM customizations...
==> default: Booting VM...
==> default: Waiting for machine to boot. This may take a few minutes...
default: SSH address: 127.0.0.1:2222
default: SSH username: vagrant
default: SSH auth method: password
default: Warning: Remote connection disconnect. Retrying...
default:
default: Inserting generated public key within guest...
default: Removing insecure key from the guest if it's present...
default: Key inserted! Disconnecting and reconnecting using new SSH key...
==> default: Machine booted and ready!
[default] No installation found.
The guest's platform ("alpine") is currently not supported, will try generic Linux method...
Copy iso file D:\sofeware\virtualbox5118\VBoxGuestAdditions.iso into the box /tmp/VBoxGuestAdditions.iso
mount: mounting /dev/loop0 on /mnt failed: Invalid argument

==> default: Checking for guest additions in VM...
default: No guest additions were detected on the base box for this VM! Guest
default: additions are required for forwarded ports, shared folders, host only
default: networking, and more. If SSH fails on this machine, please install
default: the guest additions and repackage the box to continue.
default:
default: This is not an error message; everything may continue to work properly,
default: in which case you may ignore this message.
**==> default: [vagrant-hostsupdater] Checking for host entries
The following SSH command responded with a non-zero exit status.
Vagrant assumes that this means the command failed!

mount /tmp/VBoxGuestAdditions.iso -o loop /mnt

Stdout from the command:

Stderr from the command:

mount: mounting /dev/loop0 on /mnt failed: Invalid argument**

[brunowego]

Hi @mevam, I get this issue too. This solves.