Flight Data remains on screen

[shotoverpilot]

Issue details

Please describe the problem, or desired feature

Version

What version was the issue encountered with

Board type

What type of the OSD board you are using?

How "canonical" OSD firmware works?

[ ] Works fine
[ ] The same bug
[ ] Not applicable
[ ] Not tested

TLOG and OSD

Please provide a links to a relevant screenshot/video, TLOG and OSD files that show the issue

[shotoverpilot]

After flashing the firmware, the Minimosd is plugged into the Pixhawk via the Telemetery port.

1. The OSD shows the Flight Data screen and after a little over a minute it jumps for a second or two to the custom screen then back to the Flight Data Screen. How do I remove the Flight Data screen? (I double checked the TX/RX and it is wired correctly.)

2. The voltage displayed at the bottom of the screen does not correspond to the actual voltage.

Thank you in advance.

[shotoverpilot]

Firmware version 946DV-UAVTALK

Minimosd Micro

Here's a picture of the OSD screen.
IMG_0506.HEIC.pdf

I've set my Baud rate to 115200 on the FDTI and in the OSD configurator but see 57600 on the screen. Suggestions?

Thank you again!