Skip to content

HARDWARE.md

Latest commit

 

History

History
63 lines (44 loc) · 2.29 KB

HARDWARE.md

File metadata and controls

63 lines (44 loc) · 2.29 KB
Raw

Hardware

Required hardware

🛒 PINGEQUA Flipper Zero NRF24+CC1101 2-in-1 RF Devboard

The only officially supported hardware for PINGEQUA RF Lab. One expansion module provides Flipper Zero with both nRF24L01+ (2.4 GHz) and CC1101 (Sub-GHz) chips on a shared SPI bus, with software-defined chip switching.

Worldwide shipping (195+ countries) via pingequa.com.

Pin mapping

Function Flipper pin
nRF24L01+ CSN PC3
nRF24L01+ CE PB2
CC1101 CSN PA4
CC1101 GD0 PB2 (shared with NRF24 CE — software-switched)
Shared MISO PA6
Shared MOSI PA7
Shared SCK PB3

Firmware compatibility

The app uses only standard Flipper HAL APIs. Any firmware shipping these works.

✅ Tested:

  • Momentum (mntm-dev) — primary target
  • Unleashed
  • RogueMaster

✅ Compatible by API surface:

  • Official Flipper firmware (API ≥ 87.1)
  • Xtreme

If you encounter firmware-specific issues, file a bug with the firmware version.

Channel-to-frequency reference

nRF24 ch N ↔ frequency 2400 + N MHz
nRF24 ch Frequency Common use
2 2402 MHz BLE adv 37
12 2412 MHz WiFi 1
26 2426 MHz BLE adv 38
37 2437 MHz WiFi 6
50 2450 MHz Microwave oven (ISM center)
62 2462 MHz WiFi 11
72 2472 MHz WiFi 13 (EU/CN)
80 2480 MHz BLE adv 39

Other hardware

❓ DIY or non-PINGEQUA boards: please use the hardware compatibility template to share your results — both successes and failures help the community.

⚠️ Wiring errors are the #1 cause of "Board Not Detected" reports. The PINGEQUA 2-in-1 board is plug-and-play; DIY setups require careful pin verification.

🛒 Get the recommended hardware: PINGEQUA 2-in-1 RF Devboard