TS0041/TS0042/TS0043 1-gang/2-gang/3-gang switch

[t3hk0d3]

Module: ZT3L - https://developer.tuya.com/en/docs/iot/zt3l-module-datasheet?id=Ka438n1j8nuvu
MCU: TLSR8258F1KAT32

• TS0041 _TZ3000_itb0omhv (Wireless switch with 1 button): Uses only S2 / S2 LED
• TS0042 _TZ3000_tzvbimpq (Wireless switch with 2 buttons): Uses S1/S3
• TS0043 _TZ3000_pkeqinnt (Wireless switch with 3 buttons): Uses S1/S2/S3

Link: Aliexpress

Same PCB, different front-faces.

Battery: CR2023, but can easily fit CR2034/CR2035 with no issues.

Pinout

Pin	Type	Description
D2	IN	S1 Switch (pull-down)
C2	IN	S2 Switch (pull-down)
C3	IN	S3 Switch (pull-down)
D4	OUT	S1 LED
C4	OUT	S2 LED
D7	OUT	S3 LED

Photos

[andrei-lazarov]

Hi! Thank you for the pinouts!
Please also give the Zigbee Manufacturer Names for them (_TZ3000_xxxxxx)

We don't support battery-powered remotes yet.
I will notify you

[t3hk0d3]

Hi! Thank you for the pinouts!
Please also give the Zigbee Manufacturer Names for them (_TZ3000_xxxxxx)

We don't support battery-powered remotes yet.
I will notify you

I've added IDs to the original post.

[wintersommer]

Hello, may i also add that i got a TS0043 device , with
"Zigbee-Modell
TS0043
_TZ3000_gbm10jnj"

Its also a MOE's three gang battery powered switch.

Can i help with anything ? What is the process of getting this in ? I can do changes/PR/Firmware dumps if needed

[wintersommer]

This one is a ZS3L device, i am scanning through your documentation , this one needs to be flashed by wire ? https://developer.tuya.com/en/docs/iot/zs3l?id=K97r37j19f496

[andrei-lazarov]

Hi. Yes, ZS3L is Silabs, so it must be flashed by wire. Progress is here:

• 🎉 battery optimizations #342
• Add docs on how to Flash SiLabs using Raspberry Pi #358

[wintersommer]

Would it be okay/best to create another TS0042/TS0043 2-gang/3-gang switch thread,
as it seems i captured a TELink/ZT3L Thread , and mine are all ZS3L-Silabs. I also got another 2 gang which i photographed, the 1 gangs , i still need to check for, but can be added if also SiLabs.

[andrei-lazarov]

Yes, go ahead

[andrei-lazarov]

@t3hk0d3 are the buttons active high or low?

[t3hk0d3]

@t3hk0d3 are the buttons active high or low?

I'll check today