Rifle cases induction annealing project. Never anneal pistol cases as it can soften the base resulting in catastrophic failure.
The 3D prints for the feeder I got it from Thingiverse, but the case dropper files are attached as STL for printing.
Please note that I used old uno and shield boards just because it was laying around, you can modify them as you want if you prefer to use different components
| Item | Aprox cost |
|---|---|
| Power supply | $40.00 |
| 1000W Low Voltage Induction Heating Board: | $46.80 |
| Adhesive Cable Clips | $3.20 |
| Brass Compression Tube Fitting | $7.60 |
| Copper Tubing 1/4" OD × 3/16" ID × 3FT | $8.50 |
| Insulation Braid Sleeving | $9.11 |
| DROK DC-DC Buck Volt Converter, DC 20-90V to 12V 6A | $18.00 |
| SSR-25 DD 10A DC 3-32V to DC 5-60V SSR Solid State Relay + Heat Sink | $10.60 |
| 16MM Momentary Push Button ON Off Switch Assorted | $12.18 |
| PVC Hose Tube, 8mm | $5.50 |
| ZVS 12V Water Cooling Pump | $22.93 |
| Arduino Uno REV3 | $27.60 |
| L293D DC Motor Drive Shield Stepper Motor | $7.50 |
| Nema 14 Stepper Motor | $21.00 |
| Servo motor | $10.00 |
| I2C 1602 LCD Display Module 16X2 | $11.00 |
Aprox total cost $261.52