Issues

• Baseplates: five designs the #91 and #92 sweeps left open or folded, on faces other than a flat cap

  bug
  Oliver-Johnson/DrawerForge#95 · Filter by author Oliver-Johnson opened on Oct 11, 2026
  

• Baseplates: a corner-boss plate at 32.52 mm with 4.3 mm magnets leaves 3 open edges where two bosses meet on the back edge

  bug
  Oliver-Johnson/DrawerForge#94 · Filter by author Oliver-Johnson opened on Oct 10, 2026
  

• Baseplates: a bowtie or puzzle key put in the wall from above leaves a pair of folds or four-use edges at some magnet sizes

  bug
  Oliver-Johnson/DrawerForge#89 · Filter by author Oliver-Johnson opened on Oct 10, 2026
  

• Baseplates: a corner boss stands out past a rounded plate corner

  bug
  Oliver-Johnson/DrawerForge#86 · Filter by author Oliver-Johnson opened on Oct 10, 2026
  

• Baseplates: corner pockets with a 2 mm screw hole leave open edges under the bosses at 34.04 mm

  bug
  Oliver-Johnson/DrawerForge#80 · Filter by author Oliver-Johnson opened on Oct 9, 2026
  1

  

• Baseplates: a magnet pocket and a screw bore of nearly the same width can leave bad edges

  bug
  Oliver-Johnson/DrawerForge#77 · Filter by author Oliver-Johnson opened on Oct 9, 2026
  3

  

• Backlog from the October 2026 usability review

  backlog
  Oliver-Johnson/DrawerForge#27 · Filter by author Oliver-Johnson opened on Oct 5, 2026

• STEP export for editing in CAD

  backlogenhancement
  Oliver-Johnson/DrawerForge#25 · Filter by author Oliver-Johnson opened on Oct 5, 2026

• One 3MF holding every plate

  backlogenhancement
  Oliver-Johnson/DrawerForge#24 · Filter by author Oliver-Johnson opened on Oct 5, 2026

• Lighter bins: efficient bases and wall cut-outs

  backlogenhancement
  Oliver-Johnson/DrawerForge#21 · Filter by author Oliver-Johnson opened on Oct 5, 2026

• Half-unit bins, and edge cells that use the leftover margin

  backlogenhancement
  Oliver-Johnson/DrawerForge#16 · Filter by author Oliver-Johnson opened on Oct 5, 2026