Disabling of init sequence not working

[deimi]

If the checkbox for the init sequence is disabled, the module is still doing the init sequence before sending the binary.

A workaround is to set the init sequence timings to zero even if the checkbox is not selected.

[SergiuToporjinschi]

Hi @deimi, I saw that you've done a fork for this. I had to work other projects, and now I want to ask you if your changes are solving your problem. Is true that I did not test it too much without initialization sequence, because I don't use it without it.
If it works for you can I merge back your changes? to test my scenario ?

[deimi]

Hi!
Yes my changes are working fine for receivers which are not able to handle an init sequence.

Due to lack of receivers which require an init sequence, I have checked the output of the transmitter with an oscilloscope. It looks good to me and should work for your receivers which need an init sequence.

[SergiuToporjinschi]

@deimi good if you want you can make a pull request and I will merge it.
is good that you have an oscilloscope :) I've created this node by copying the radio signal using an 433 sniffer and measure the timing for each bit. And because is so hard for me to debug I'm not doing too many changes to it because if something go wrong is a nightmare to debug.

[deimi]

I already made a pull request for this in november after I verified the changes in my fork.
See #4

[deimi]

@SergiuToporjinschi status?