This repository contains everything you need to use WaziDev.
It can be loaded as a sketchbook in Arduino IDE.
➡️ Check out the wazidev library examples
You can clone this repo with:
git clone git@github.com:Waziup/WaziDev.git
ATTENTION, this repo use a "subtree" for WaziDev library. The subtree is in libraries/WaziDev. You can get the last change to the library with:
git subtree pull --prefix libraries/WaziDev/ --squash wazidev-lib master
If you made changes to the WaziDev library, push them to the original repo of the library:
git subtree push --prefix libraries/WaziDev/ --squash wazidev-lib master
If you use Wazidev v1.4 or above, there is a support automatically for LMIC lib. However, if you have Wazidev 1.3 you need to enable it via a small soldering as shown below:
- So as shown, you only need to Solder the JR pad which connects the DIO0 of the Lora module to pin D2 of the Atmega chip.
- Also, you need to pick a wire and solder one end on where it is shown on the Lora module (which is DIO1) and another end to the D3 pin of the Atmega chip. You can also use a jumper whire and plug one end to D3 and solder the other end on DIO1 as shown.
WaziDev is based on the design by Fabien Ferrero.