You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
Repository navigation
mesh-compile: mesh a curved operand by its section angle against a curved face #505
Follow-up to #380 (f24933a, ADR 0080). A boolean's curved operand is now meshed at its chord budget times the sine of the smallest angle at which it meets a plane face of the other operand. That is computed in closed form for a plane against a cylinder, cone, sphere or torus, over the face's parameter box. These pairs are not covered and keep the plain chord budget, so their cut can still miss the budget where they meet obliquely; the deviation report measures it and says so:
a curved face against a curved face (a pipe through a pipe, a cylinder against a sphere or torus);
elliptical cylinders, B-spline surfaces and surface relations;
authored-mesh operands;
contacts grazing below the 0.25 floor (14.5 degrees).
The first is the common case in building models (pipe tees, round ducts through round columns). The section angle of two quadrics needs their intersection curve, or a certified lower bound on the angle between the normals along it, for example from the two surfaces' normal cones over a subdivided parameter box.
Done when a curved/curved pair of the common quadric families gets a factor with a stated argument, with tests where the plain budget misses and the factor meets it, plus a probe.
Activity