0.21.1

Release Notes:

• Raspberry Pi RP2040 Board updated to 4.5.4
• GFX Library updated to 1.6.0
• TinyUSB library updated to 3.6.0
• Pico PIO USB updated to 0.7.2
• Adafruit_SSD1306 updated to 2.5.14

0.21.0

Release notes:

• new HID event # function count (press BOOTSEL > 2 sec). See Issue #53
• frequencies adjusted for Pico1 or Pico2 to maximise compatibility
• GFX Library updated to 1.5.3
• Raspberry Pi RP2040 Board updated to 4.4.2

RESET is still executed with BOOTSEL pressed for less than 2 sec.

0.20.0

Release notes:

• added firmware for Pi Pico 2 based devices
• some concurrency issues fixed
• TinyUSB library updated to 3.4.2
• GFX Library updated to 1.5.0
• Adafruit_SSD1306 updated to 2.5.13
• Raspberry Pi RP2040 Board updated to 4.4.0

0.19.1

Release notes:

• TinyUSB library updated to 3.4.0
• Adafruit_SSD1306 updated to 2.5.12
• GFX Library updated to 1.4.9
• Raspberry Pi RP2040 Board updated to 4.1.1

0.19.0

Release notes:

• TinyUSB library updated to 3.3.3
• Adafruit_SSD1306 updated to 2.5.11
• Raspberry Pi RP2040 Board updated to 4.0.1 (ready for Raspberry Pi Pico 2)
• Pico PIO USB updated to 0.6.1

0.18.2

Release notes:

• Raspberry Pi RP2040 library updated to 3.9.3
• TinyUSB library updated to 3.3.1
• Dockerfile contains now versions, so the build is consistent

NOTE: pio_usb library has been updated, but I'm sticking to 0.5.3 for now, because I saw some instability in the behavior (need to disable some optimization to get it working right)

0.18.1

Release notes:

• Raspberry Pi RP2040 library updated to 3.8.1
• ``GFX Library for Arduinolibrary updated to1.4.7` (used by PIWATCH version)
• all screen output is now sent to serial, so USBvalve can be now used without a screen (Issue #46)

0.18.0

Release notes:

• moved to Adafruit_SSD1306 library to increase compatibility (Issue #40)
• TinyUSB library updated to 3.1.4
• Raspberry Pi RP2040 board updated to 3.8.0

Note: if you are going to compile from sources packaged here, be careful that I left accidentally un-commented line 24, so the default compilation will be for the PIWATCH. I already switched the default back in the main repo.

0.17.0

Release notes:

• TinyUSB library updated to 3.1.3
• the on-board LED is now used as additional WARNING method (Issue #21 thanks to @TryBreakFixAgain for the suggestion)
  GREEN: all OK
  OFF: something suspicious

0.16.0

Release notes:

• TinyUSB library updated to 3.1.1
• GFX library update to 1.4.6
• added initial support for detection of Host devices different from HID (Issue #20); mass storage and CDC devices:

[++] CDC Device
[++] Mass Device

for the time being they are just detected, no additional actions are performed