Test alarm on hub

[depuits]

Is it possible to initiate a test alarm using the hub "id" (0)? As the readme says you can only silence using the hub so it might be nice to be able to test it from there too. If the protocol does not support it then it wouldn't be to difficult to implement it in this code, but I first wanted to check if it is actually possible or not using the same method as the silence.

[Skons]

This is very good possible, i think id 0 should be catched somewhere here

elro_connects/elro/mqtt.py

Line 159 in 6ea49cb

elif "state" in mqtt_message_json:

Then the existing devices need to be ennumerated and bam, bob’s your uncle. I cannot test this anymore because testing it will drive my family into madness 😅.