Configuration files of Marlin 1.1.x bugfix version for sovol sv01 3d printer.
This is not part of an official firmware check the sovol warranty limitation.
The filament runout detector is now activated.
The bed is limited to 285mm instead of 290mm to avoid going outside the bed.
The filament unload as to be done manually to limit clogging issues.
I recommand to backup your firmware before uploading a new one. To do so on a Linux:
avrdude -C/AbsolutePathToConfigFiles/avrdude.conf -v -patmega2560 -cwiring -P/dev/ttyUSB0 -b115200 -D -Uflash:r:/AbsolutePathWhereToBackup/dump.hex:i
You will/may have to change AbsolutePathToConfigFiles, /dev/ttyUSB0 and AbsolutePathWhereToBackup
- Thanks to Daniel Re for the filament runout sensor configuration code