Burn_the_bootloader
Maybe you will receive a microprocessor which is not bootload or with an old version, so you will have to do it yourself.
This instruction is here to help you :
If it's to hard you can watch these websites, the first is in english, the second in french :
https://maniacbug.wordpress.com/2011/11/27/arduino-on-atmega1284p-4/
http://menututo.com/mettre-un-bootloader-arduino-dans-un-atmega1284p/
You msut have the good software, files, equipment :
-Arduino 1.0 : https://www.arduino.cc/en/Main/OldSoftwareReleases
-The files of the bootloader : https://github.com/netbomo/mighty-1284p
Copy the bootlarder file in the arduino like this /Arduino/hardware/mighty-1284p
-An arduino card
Open the IDE Arduino, Tools, board and select the Windlogger_digital_Board
If you didn't see the board, go back in your arduino files and copy the interior of the folder apr in the mightu-1284 folder and delete the apr folder (normally it is with your other file and empty)
Retry the operation and select the good board.
The pins P3 allows to connect the arduino board to the digital board, you have to follow this schema :
The pin gnd is at the top left, below it is the reset, the below schema is not in the right direction
If you didn't have an arduino uno card you have to change the pins like this :
Connect your arduino card (log on your digital board) to your computer, open the ISP exemple you can find it in your arduino folder > Exemples > ArduinoISP and burn the sketch onto a regular Ardunio (select your board in Tools/board/"your arduino bord")
After change the board for the windlogger_digital_Board, the programmer for « Arduino as ISP » and do "Burn the bootloader".
You have successfully bootloaded your card