Repository navigation
Conversation
48c200d to
33e3d1f
Compare
- Detect BCM43602 (14e4:43ba) via lspci - Bundle cristianmiranda NVRAM config in repo - Install with MAC address substitution - Wire into install/hardware/all.sh - Add migration for existing installs - Add 18 tests, all passing Fixes omacom#11613
33e3d1f to
955fac3
Compare
|
Thanks for writing this up, @andyholst. I reviewed it at This pull request competes with #7671, and #7671 is the one to carry. Both install a BCM43602 calibration file for these Macs. #7671 does it only on MacBookPro14,2 and 14,3, under Why not this one:
Your measurement (-90 dBm to -58 dBm on your 13,3) is real data for the 13,3 question, and it sits next to a 13,3 report where the same file broke 2.4 GHz. If you can post your Wi-Fi card's subsystem ID ( Next: the maintainer decides between these pull requests. I am not bringing this one to ready alongside #7671. |
|
Thank you for this, @andyholst. #7671 fixes the same problem in a way the review judged better, so this is closed in favour of it. If it does not cover your case, please say so there. Closed at the maintainer's request. The review comment above has the details; it was done by Claude Opus 5.5 with Codex Medium as a second opinion, whose agreement is not independent. |
Problem
MacBook Pro 2015-2017 with BCM43602 (brcmfmac) gets -90 dBm signal — barely usable past 1 meter.
The root cause is the NVRAM config loaded by the brcmfmac driver is too generic. It lacks proper power amplifier settings and antenna gain parameters for the MacBook's hinge-antenna design.
What Didn't Fix It
All help with connecting but NOT signal strength.
Fix
Install cristianmiranda's improved NVRAM config which has proper board flags, antenna gain, and power amplifier parameters specific to MacBookPro13,3:
The NVRAM config file is bundled directly in the repo — no download needed at install time.
Result
32 dBm improvement — 5GHz now works reliably at full speed.
Changes
Testing
Reference: #4692 (reply in thread)
Fixes #11613