Playback software and installation notes for Arnold Reinthaler's under construction.
The installation plays a video of a watch in step with local time. The artist describes the work as a 24 × 24 × 5 cm installation with a 720-minute (12-hour) PAL video loop, in colour and with sound. This repository contains the technical companion to the artwork; the video itself is not included.
The original Raspberry Pi setup from 2013–2016 is preserved in
legacy/. It used a Ruby launcher and a modified omxplayer.
Those files are historical reference material and are no longer the recommended
installation procedure.
The replacement is planned around a standard mpv package, with no project-maintained player fork. The installation guide covers preparing the Zero W, video conversion, network time and manual playback tests. It is a draft awaiting hardware validation; the modern synchronisation controller and permanent startup service are not yet implemented.
- Raspberry Pi Zero W, running a supported 32-bit Raspberry Pi OS Lite image.
- Local video on microSD, converted to a compatible H.264 format if needed. Conversion should preserve the work's timing, aspect ratio and sound.
- mpv for playback, controlled through its local JSON IPC interface.
- Wi-Fi and NTP to synchronise the system clock.
- A small controller to map local time to the video position, keep playback aligned, and recover after interruptions.
- A systemd service to start the controller automatically and restart it after a failure.
The Zero W is the intended first target. Hardware decoding, seeking, audio and the loop transition still need to be checked with the actual video and display on the selected OS/mpv versions.
After boot, playback should wait for successful network time synchronisation, then start at the position matching the current local time. NTP keeps the system clock accurate; the controller must separately check and correct video drift. The timezone and daylight-saving behaviour should be explicit.
The legacy launcher assumes a 12-hour cycle whose first frame represents 07:00:00. For that mapping:
video position = (seconds since local midnight - 7 × 3600) modulo 43200
The first frame and exact duration must be verified against the playback file, especially after conversion. The initial seek position must not become the start of every subsequent loop.
If Wi-Fi is lost during playback, the device can continue using its system clock. Without a battery-backed real-time clock, a fresh boot needs successful NTP synchronisation before the displayed time can be trusted.
- Inspect the source video and prepare a playback copy, preserving the master.
- Verify mpv playback and hardware decoding on the Zero W.
- Implement configurable clock mapping, drift correction and restart handling.
- Test complete loops, power cuts, network loss and daylight-saving changes.
- Validate the installation guide and record the tested OS, packages, configuration and recovery procedure.
See the legacy overview for the original launcher, setup notes and their limitations. The planned setup does not depend on the former omxplayer fork.
The project's original software is available under the Unlicense. Third-party software and quoted code retain their respective licences. Using an unmodified player does not remove its licence obligations when distributing it with an installation or disk image.
The software licence does not grant rights to Arnold Reinthaler's artwork, video, photographs or other artistic material. Those require separate permission from the relevant rights holders. Consult the artist's work page for the artwork itself.