Skip to content
Open
Changes from all commits
Commits
File filter

Filter by extension

Filter by extension

Conversations
Failed to load comments.
Loading
Jump to
Jump to file
Failed to load files.
Loading
Diff view
Diff view
42 changes: 40 additions & 2 deletions arch/arm64/boot/dts/apple/t6050-j716c.dts
Original file line number Diff line number Diff line change
Expand Up @@ -176,11 +176,12 @@

/*
* Pin 112's register (0x29c0001c0) takes an SError when read, so only the pins a node
* here names are exposed: 80 (PCIe port 0's PERST#, ADT pci-bridge0 function-perst).
* here names are exposed: 80 (PCIe port 0's PERST#, ADT pci-bridge0 function-perst) and
* 138 (the Touch ID sensor's data-ready line).
* A reserved line cannot be requested, so a node that names a new pin opens it here too.
*/
&pinctrl_ap {
gpio-reserved-ranges = <0 80>, <81 140>;
gpio-reserved-ranges = <0 80>, <81 57>, <139 82>;
};

/* This board's SMC fan and power keys are not yet checked */
Expand Down Expand Up @@ -246,6 +247,43 @@
63 2e 00 06 02 69 4f 53 00 00 00 00];
};

/*
* Touch ID (ADT spi2/mesa), wired as on the J714s: the Mesa sensor (sensor-id
* 0x3356) at 8 MHz on chip select 0, powered by NUB GPIO 21 (function-mesa_pwr),
* data ready on AP GPIO 138. The controller's clock (ADT clock-ids 451) is the
* 24 MHz reference.
*/
&ps_nub_gpio {
status = "okay";
};

&nub_gpio0 {
status = "okay";
};

&ps_spi2 {
status = "okay";
};

&spi2 {
clocks = <&clkref>;
status = "okay";

mesa: fingerprint@0 {
compatible = "apple,mesa-fingerprint";
reg = <0>;
spi-max-frequency = <8000000>;
spi-cpol;
spi-cs-setup-delay-ns = <20>;
spi-cs-hold-delay-ns = <20>;
enable-gpios = <&nub_gpio0 21 GPIO_ACTIVE_HIGH>;
interrupt-parent = <&pinctrl_ap>;
interrupts = <138 IRQ_TYPE_EDGE_RISING>;
/* Per-device factory data from this Mac's own iBoot system container */
firmware-name = "apple/mesacal-j716c.bin", "apple/msrk-j716c.bin";
};
};

#include "t6050-j716c-isp.dtsi"
#include "t6050-j716c-gpu-panel.dtsi"

Expand Down
Loading