Skip to content

First Workout

Devil edited this page Nov 15, 2026 · 2 revisions

First Workout

Use this path when you want to confirm the app can connect and complete a simple session.

1. Connect To The Trainer

  1. Power on the Vitruvian machine.
  2. Open Project Phoenix.
  3. Grant Bluetooth permissions when prompted.
  4. Start from the Workout tab and use the trainer connection control to scan/connect. Wait for a connected status before starting cable work.
  5. If the trainer does not appear, move closer, confirm Bluetooth is on, and power cycle the trainer.

Android 11 and older also need Location enabled for BLE scanning. This is an Android BLE requirement.

2. Choose A Starting Flow

The Launch Pad gives you the main user-facing paths:

  • Just Lift: quick sets with minimal setup.
  • Single Exercise: pick one exercise, configure the mode, weight, reps, and optional replay from recent activity.
  • Routines: run a saved routine exercise by exercise.
  • Training Cycles: start the routine assigned to the current day of an active cycle.
  • Assess 1RM: run the VBT-based 1RM assessment flow when the trainer is connected.

For a first test, use Just Lift or Single Exercise with a conservative weight.

3. Just Lift

  1. Tap Just Lift.
  2. Choose a mode. For fixed-load modes, choose a conservative weight per cable; Echo instead uses its level and eccentric-load controls.
  3. Wait for AUTO-START READY, then grab the handles and follow the start countdown. If you see Connect to enable auto-start, connect the trainer first.
  4. Complete a set and review the set summary.
  5. Tag the exercise after the set if you want the workout to count toward exercise history and PR tracking.

Just Lift is good for quick testing because it does not require a saved routine.

4. Single Exercise

  1. Tap Single Exercise.
  2. Pick an exercise.
  3. Configure weight, reps, mode, Echo level or eccentric load if applicable.
  4. Start the set and follow the countdown or motion-start behavior configured in Profile → Workout Behavior.
  5. Review the set summary.

Recent Activity links can reopen a previous exercise into Single Exercise so you can repeat work without searching the library again.

5. Routine Starts

Routines may start from an overview screen or auto-start depending on Profile → Workout Behavior preferences. If Auto-Start Routine is enabled, the app can skip the overview and move directly into the first set when the trainer is connected.

Warmups, rest timers, and per-set behavior are controlled by the routine configuration. Review the next exercise and load before continuing, especially when autoplay is enabled. The Set Ready screen also shows quick exercise history when available.

6. Calibration And Warmups

  • Start light until you know the machine is responding correctly.
  • Keep the cable path clear before the countdown ends.
  • Watch for unexpected resistance, missing audio cues, or connection drops.
  • Use Diagnostics-and-Troubleshooting if the machine reports faults or the app disconnects.

Understand The Load Before Starting

Cable weights are per cable, not a combined machine total. For example, 20 kg per cable is 40 kg across two loaded cables. The hardware ceilings are 100 kg per cable for V-Form and 110 kg per cable for Trainer+; these are limits, not recommended starting loads.

If you use Equipment Rack items, check the selected items and whether each is added load or counterweight before starting. Bodyweight/non-cable exercises use their own timed-set and accessory-load controls, not trainer resistance. Choose the correct profile so its preferences and history are used.

Clone this wiki locally