Skip to content

Assembly

David Kadish edited this page Mar 4, 2026 · 10 revisions

Board Preparation

Equipment/Parts

  • Soldering iron
  • Tweezers
  • Solder
  • 100kOhm resistor (through-hole)
  • Exacto knife

Steps

  1. Heat up and remove the resistor at R20
  2. Cut JP5 just after R22
  3. Insert and solder the 100 kOhm resistor in the place where R20 used to be between R22 and R25.

This makes the following config:

  • R20 (RCOM) = 100k
  • R22 (RLONG) = OPEN
  • R25 (RRange) = 47.3K
  • R26 (RPeriod) = 115K

So, the chip:

  • Starts in RUN mode
  • NRANGE is 256
  • tperiod is 73.6s, so it should shutdown for just over 1 minute

Enclosure Preparation

  • 0.05 Hex Screwdriver
  • Small Pliers

Notes

The ESLOV and Qwiic cables are in the correct orientation in the v2.0.1 hardware and do not need to be re-wired/reverse connected.

Antenna

Power Connector

  • Soldering Iron
  • Solder
  • Helping Hands
  • JST Connectors
  • Heat shrink tubing

Bottom Case

  • Pliers (Support removal)
  • M2 Heat set insert soldering iron attachment
  • Heat set inserts
    • 5x M2x5x3.2
    • 1x M2x2x3.2

Steps

  1. Remove support materials
  2. Insert threaded inserts

Top Case

  • Pliers (Support removal)
  • M2 Heat set insert soldering iron attachment
  • Heat set inserts
    • 2x M2x2.5x3.2

Steps

  1. Remove support materials
  2. Insert threaded inserts

LoRaWAN Connection

Steps

The instructions at https://wiki.seeedstudio.com/LoRa-E5_STM32WLE5JC_Module/#13-connect-and-send-data-to-the-things-network and https://wiki.seeedstudio.com/LoRa-E5_STM32WLE5JC_Module/#lorawan-end-node are also helpful here.

  1. Go to the Things Network Console and select Register end device in the desired Application
  2. Fill in the device specifics manually Screenshot 2025-03-14 at 00 28 00
  3. Upload the example SerialPassthrough sketch to the device.
    • NOTE: This seems to only work at 9600 baud and using TyCommander
  4. Enter the JoinEUI (AppEUI) and DevEUI (AT+ID=AppEui and AT+ID=DevEui via TyCommander
  5. Generate an AppKey and add that to the device using the command AT+KEY=APPKEY,"[KEY HERE]"
  6. Give the device a name
  7. Connect to the network using the following AT Commands
  • AT+DR=EU868
  • AT+CH=NUM,0-2
  • AT+MODE=LWOTAA
  • AT+JOIN
  1. Upload BAIT firmware using PlatformIO Upload

Clone this wiki locally