Skip to content

Testing Upon Arrival

David Kadish edited this page Mar 17, 2025 · 6 revisions

Testing Upon Arrival

No 3.3V, Low Power Chip Failure

Description

The 3.3V line is not coming up on boot. It seems like the issue is that there are incorrect resistor values around the low power chip, causing it to start in shutdown mode.

The resistors are placed as follows (R? - EXPECTED - ACTUAL)

  • R20 - 100k - 61.9k
  • R22 - 1.02M - 61.9k
  • R25 - 61.9k - 47.3k
  • R26 - 115k - 115k

Photo on 2025-03-10 at 22 52

Cause

The issue arises from the BOM document. Many resistors are listed (in the Device column) as SMD-RES-100K-1%-1/10W(0603), when in fact, they have other values and I think I didn't catch the error in creating the final BOM.

TODO: Double check this and all other resistor values.

BUT THIS IS NOT WHAT IT SAYS IN THE BOM. CHECK THIS WITH SEEED. AND DOUBLE CHECK THE OTHER ONES...

Fix

Wait

Oh, no. I made a mistake here. I was measuring resistances, but that gives the resistance of the network, not of the resistor itself. By the markings:

(R? - Code - EXPECTED - ACTUAL)

  • R20 - 01D - 100k - 100k
  • R22 - 01D - 1.02M - 100k
  • R25 - 77C - 61.9k - 61.9k
  • R26 - ?? - 115k -

3.3V regulators

These are behaving strangely and don't see to be turning things on and off, but I have to check with a multimeter.

It seems like the pullup resistors on these are 1 ohm, not 100 kohm like they should be. Double check this in the BOM, but I think Seeed screwed up.

I2S Microphone connector

I connected this in the wrong direction on one of the boards.

Headphone Jack

Headphone jack is not working. The SGTL5000 is working because I2C commands work and the board shows up as a USB source and is able to produce sound using the sgtl5000_simpledrum_over_usb sketch that is used as USB input sound. But nothing comes out over the headphone jack.

TODO: Check the resistors and jack wiring.

RTC

RTC seems to work perfectly using the https://github.com/MacroYau/RV-3028-C7-Arduino-Library library. Two examples in the testing folder set_ and print_datetime seem to work even when unplugged from computer. Should be tested again in a day or two to make sure it's still good!

Clone this wiki locally