Repository navigation
Electronics
David Kadish edited this page Jul 6, 2024
·
12 revisions
- Check Voltages
- ESP32 blink test
- Teensy blink test
- Buzzer
- Working, very quiet, unlikely to be very useful. Does not work with Teensy Audio Library.
- Test file 8.buzzer_self_test: Teensy audio library ToneDetect finds tones at low detection levels in the lower (200-400Hz) frequency range. Possibly useful for something, but sound level is still very low.
- BQ27441 (fuel gauge)
- Working, seems to be registering battery charge. Current and power measurements may reflect charging and not usage. Need to check.
- LoRa E5
- SGTL5000 (Audio CODEC)
- NOT WORKING Missing connections on pins 21, 23-26 for I2S, which is a core functionality.
- SD
- Working in basic test with
SdFat(Teensy library)
- Working in basic test with
- QWIIC Power
- Qwiic working for screen. RED FLAG pins on qwiic connectors are reversed.
- Power cycling DOES NOT work for the OLED display (doesn't start again), but does work for the temperature sensor TMP117
- Details in the Power page
- Add a passthrough qwiic connection ?
- RTC
- BQ24074 (analog testing w/ solar panel)
- BME680 (temperature/humidity/pressure/gas)
- I2C address has to be set at 0x76 (instead of the default 0x77)
- TSL25911 (light)
- SPH0645 (mic)
- ICS43432 (mic)
System draws ~125 mA on basic operation mode. This includes:
- Teensy
- OLED Display
- Fuel Gauge
- No sensors/microphones
- No SD
During that, when in full sun, the large (3.4W) solar panel was charging the battery with a current up to 450 mA (which means 575 mA when accounting for the system draw). The 6600 mAH battery went from about 65% to 90% in a few hours under that.
| Type | Detail | Quantity | Part | Comments |
|---|---|---|---|---|
| Screw | M2 x 6 | 2 | Sensor Mount | |
| Screw | M2 x ? | 2 | Board to base | |
| Screw | M2 x ? | 4 | Cover to base | |
| Heat Set Insert | M2 x 5 x 3.5 | 6 | Base | |
| Heat Set Insert | M2 x 2.5 x 3.2 | 2 | Sensor Mount | |